Needs To Be Painted In Order To Match Color Of Your Car, Even If Your Car Is WHITE. AIT Plastic resins - AIT special plastic resin is a hybrid form of polyester resin which has been toughened with epoxy molecules within the main molecular structure. AIT resins offers better resistance to moisture absorption than regular polyester resins. Gelcoat - provides high impact strength, excellent gloss, it is water resistance and helps prevent blisters from forming after laying the fiberglass mat.
Does not expand or shrink with temperature change. High strength to weight ratio. Chemical resistant except for hydrofluoric, hot phosphoric acids, and strong alkaline substances. Vinyl Ester Resin - This gives superior flexibility and strength than that of polyester resin.Multi-Layer Fiberglass - Our pieces have 4 oz. Layers of hand-laminated fiberglass with a plastic gel coat finish. Strong Gel Coat Finish - This results in a SMOOTH finish and adds extra strength to the part! Please be careful because other manufactured finished body kit parts will have orange peel rumples. Fitment - Our pieces have a much BETTER QUALITY fit when compared to. IS FOR lower 48 states. We deliver to both home or business locations. As long as you follow proper instructions. Please make sure to include your item # Failure to comply with this policy may result in a denial for damage claim. All our products requires professional installation and is highly recommended. Images are for references only. FRP Composite/Carbon FRP Composite Hoods.
Before you start, please make sure you have the proper safety equipment to avoid potential harm to you and your vehicle. FRP Composite/Carbon FRP Composite hood installation can relatively be an easy process; anyone with a little mechanical knowledge should be able to install parts in a few hours. Tools are also very standard, and if you have taken your factory parts before, replacing it with an aftermarket piece should be no trouble at all.Remove factory hood from the bolts at the end of the hinges. (Do not remove the hinges).
Install new aftermarket hood by reverse process. Tighten bolts to just enough torque to hold the hood in place, but lose enough to be adjusted by a tug. Remove hood latch and check alignment.If the hood is not aligned properly, adjust accordingly and tighten bolts at the hinges. Re-install hood latch and adjust for fitment.
If the hood is latched but not fully close, the latch might need to be adjusted shorter. If the hood does not latch down, the latch might need to be adjusted longer.Check for fit and youre done. Vendor is not liable for any damages or injury as a result of these products. Purchaser is responsible for complying with any/all local, state, and federal laws regarding the addition or modification of parts. We disclaim any liability from the removal of reinforcements, bumpers, turn signals, and other safety equipment on the vehicle.
Professional installation of body kits and body related parts i. Bumpers, side skirts, hoods, fenders, etc. Hood pins are highly recommended for aftermarket hoods. Vendor is not responsible for any items damaged during installation. Please Keep The Original Packaging For At Least (90) Days.It Will Be Up To Amerihood To Replace, Credit Or Repair Said Defective Part. In The Event Of A Defect In Material Or Workmanship, Amerihood Shall Not Be Responsible For (A) Actual Or Alleged Installation Labor, Transportation Or Other Incidental Charges; (B) Actual Or Alleged Consequential Or Other Damages Incurred By Use Of Amerihood Products; (C) Injury Or Any Damages Arising Directly Or Indirectly From Any Defects In Its' Goods, Defective Or Otherwise. The item "2018-2019 JEEP WRANGLER JL VIP STYLE FUNCTIONAL HEAT EXTRACTOR RAM AIR HOOD" is in sale since Saturday, July 13, 2019. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Exterior\Hoods". The seller is "autotwerks" and is located in Chino, California. This item can be shipped to United States.