Images are for references only. FRP Composite/Carbon FRP Composite Hoods. Before you start, please make sure you have the proper safety equipment to avoid potential harm to you and your vehicle. FRP Composite/Carbon FRP Composite hood installation can relatively be an easy process; anyone with a little mechanical knowledge should be able to install parts in a few hours. Tools are also very standard, and if you have taken your factory parts before, replacing it with an aftermarket piece should be no trouble at all.
Remove factory hood from the bolts at the end of the hinges. (Do not remove the hinges). Install new aftermarket hood by reverse process. Tighten bolts to just enough torque to hold the hood in place, but lose enough to be adjusted by a tug. Remove hood latch and check alignment.
If the hood is not aligned properly, adjust accordingly and tighten bolts at the hinges. Re-install hood latch and adjust for fitment. If the hood is latched but not fully close, the latch might need to be adjusted shorter. If the hood does not latch down, the latch might need to be adjusted longer. Check for fit and youre done.
Vendor is not liable for any damages or injury as a result of these products. Purchaser is responsible for complying with any/all local, state, and federal laws regarding the addition or modification of parts.
We disclaim any liability from the removal of reinforcements, bumpers, turn signals, and other safety equipment on the vehicle. Professional installation of body kits and body related parts i. Bumpers, side skirts, hoods, fenders, etc. Hood pins are highly recommended for aftermarket hoods. Vendor is not responsible for any items damaged during installation.
The item "2008-2020 DODGE CHALLENGER HELLCAT CARBON FIBER HOOD WITH HEAT EXTRACTOR VENTS" is in sale since Tuesday, October 22, 2019. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Exterior\Hoods". The seller is "autotwerks" and is located in Chino, California. This item can be shipped to United States.