HIGHLIGHTS: TWEETER MP 25.3. Tetolon fiber soft dome, for a natural yet detailed reproduction of musical nuances. "Center Tuning Duct" geometry, for lower resonance frequency and reduced harmonic distortion. High density flux Neodymium magnet, optimized for utmost control during high energy dynamic transients in the mid-high frequency range. 25mm ferrofluid-cooled mobile voice coil.
Rear chamber filled with selected damping material and sized for lower Fs, to ensure a well damped high pass frequency roll-off, allowing low cut-off frequency crossover point. Faceplate featuring FEM (Finite Element Modeling) optimized geometry, for high linearity in off-axis installations. Wide array of installation accessories, for an easy OEM integration.
Symmetrical dual Neodymium magnet structure specifically developed with FEM (Finite Element Modeling) simulations, for superior dynamics and control. Exponential V-cone® profile pressed-pulp cone with cotton fibers, combining stiffness and lightweight for a wide frequency response. Cone profile geometrically optimized for utmost linearity and dispersion in the mid-high frequency range. "Boundary Free" rubber surround, for better efficiency and wider mid-bass frequency. Anti-vibration rubber magnet cover, to damp spurious vibrations, removable to fit limited mounting depth installations.
Acoustically transparent aluminium alloy basket with elegant diamond cutting and featuring the aluminium Hertz logo. Full protection metal mesh grill featuring the aluminium Hertz logo and attractive look mineral powder coated inner grill are included for several install combinations. Cone profile geometrically optimized for utmost linearity and dispersion in the mid frequency range. "Boundary Free" rubber surround, for improved efficiency and wider mid-bass frequency. High density flux ferrite magnet combined with very low carbon content iron plates, for low distortion at high power levels.
Low mounting depth, acoustically transparent aluminium alloy basket with elegant diamond cutting and featuring the aluminium Hertz logo. Two-position (0 / +2 dB) switch for tweeter & midrange level adjustments, to fine-tune the transducers emission according to their installation position. 100V extremely high quality bi-metallized polyester film capacitors in the tweeter section, for maximum sound transparency and neat hi-frequencies. 1mm pure copper wire low series resistance inductors, for low dissipation losses on the woofer section where high transient currents are demanded. Compact footprint design for easy installation, with top vent grille for efficient heat dissipation.
165 (6.5) Midrange mm in. 70 (3) Tweeter diaphragm mm in. 25 (1) Midrange mm in.20 (0.8) Tweeter mm in. Peak 300W Continuos 150W RMS. Sensitivity dB SPL 92 Impedance O 4 Frequency Response Hz 40 ÷ 22,5k.
Woofer Lo-Pass 450Hz - 6 dB Oct. Midrange Band-Pass 450 ÷ 5.5k Hz - 6 dB Oct. Tweeter Hi-Pass 5.5kHz - 12 dB Oct.
Adjustment Tweeter level 0 / +2 dB. Midrange level 0 / +2 dB. Woofer kg (lb) 1.07 (2.36) Midrange kg (lb) 0.17 (0.37) Tweeter kg (lb) 0.07 (0.15) Crossover kg (lb) 0.43 (0.95).
This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Car Speakers & Speaker Systems". The seller is "audio_for_fun" and is located in this country: AT. This item can be shipped to Canada, all countries in Europe, all countries in continental Asia, United States, Brazil.